As found, the mill was not under power but had been represented as "working". It had been wired for 440 volts, 3-phase.
It had only a little tooling. A vise, some collets, an incomplete set of hold-down clamps and a plexiglass shield.
This appeared to work well. No vise handle was available, "We just use a wrench."
Several missing pieces and, while dirty, not a lot of use on what was present.
I removed the vise and was presented with a lot of rusty swarf in the T-slots.
I scraped out a lot of the swarf and left it in their collection bin.
I removed the handles and power feed and tilted the head in preparation for transport.
Obviously not a lot of wear on the Y-axis.
Comments
Post a Comment